Key Facts
Recommended on
Bonding substrates such as: PVC, polycarbonate, acrylic, ABS, FRP, Nylon™, Mylar™, Delrin, phenolic, aluminum and stainless steel
Properties
- High impact resistance: will not crack when drilled
- Resistant to water and most common solvents and shop fluids
- Versatile product that can be used in many different applications
- Will not shrink
- One-time application
- Convenient double syringe
- Dispenses equal amounts of each component every time
- Handling strength achieved in 20 to 25 minutes
- Quick completion of project
Step by step
HOW TO USE:
Step 1: Safety Precautions
Apply and cure in a well ventilated area. Wear gloves and wash hands after use.
Step 2: Preparation
Surfaces must be clean, dry and free from oil, wax and paint. Roughen smooth surfaces with 220 grit sandpaper prior to cleaning. To clean surfaces, wipe with rubbing alcohol. Pre-fit parts to be joined. Remove the plug from between the piston. Cut off the end tips of the syringe. Turn syringe end up and pull plunger back slightly allowing air bubbles to rise to top. Press the plunger to dispel the air. Depress the double piston to dispense equal parts of the two materials on a disposable surface. Mix both components thoroughly until a uniform color is achieved. Wipe syringe tips clean, retract piston slightly and close with the plug. Ensure that the plug is always placed in the same orientation on the tips.
Step 3: Application
Apply a small amount to both surfaces, join and press together. Support parts until bond sets in approximately 20 to 25 minutes at room temperature. After the fixture time is achieved the material has reached handling strength.
Step 4: Cleanup
Remove any excess uncured adhesive immediately using mineral spirits, isopropyl alcohol or denatured alcohol.