- Decorative laminate/trim work, marine applications, upholstery work, van/motor home conversions, kick plates and signage
- Bonding wood, metal, glass, carpet and plastics (polypropylene, acrylics, PVC and more)
- High temperature resistant
- Can be used outdoors
- Dries clear and will not yellow with age
- Invisible bond
- Can apply multiple coats
- Increases bond strength
- Does not bubble
- No reworking
Step by step
HOW TO USE:
Step 1: Safety Precautions
Well-ventilated area, wash hands after use.
Step 2: Preparation
Apply adhesive between 18°C and 35°C. Shake can well before using. Surfaces must be clean, dry and free of foreign materials. Protect finished surfaces. Pre-fit all materials. Testing of substrates for compatibility is recommended. Repositioning is not possible. Turn spray tip so that the black dot is aligned with the nozzle.
Step 2: Application
Hold can in a vertical position. Point valve towards surface and spray from a distance of 20 to 25 cm. Keep the can moving to create an even coat and avoid build-up on the surface. Start and stop the spray just off the work to prevent runs and sags. Apply an even coat to both surfaces to be bonded and allow to dry 2 to 5 minutes between coats. Apply maximum pressure over entire surface. Adhesive loses tack after approximately 10 minutes. Recoat if time exceeded. Porous surfaces will require more than one coat.
Step 3: Cleanup
After use, invert spray can and spray for approximately 2 seconds (or until spray is free of adhesive) to clear valve and spray tip. Clean spray tip with turpentine or mineral spirits.
Note: When using solvents for cleanup, use proper precautionary measure.