Bonding wood, metal, acrylic, foam, fabric, polyethylene and polypropylene, PVC, cardboard, leather, felt, carpet, corkboard, glass, foil rubber and most plastics
- Repositionable or permanent bonding
- Variety of applications
- Dries clear and will not yellow with age
- Invisible bond
- Can apply multiple coats
- Increases bond strength
- Does not bubble
- No reworking
- Acid Free
- Will not damage photographs
Step by step
HOW TO USE:
Step 1: Safety Precautions
Apply in a well-ventilated area, wash hands after use.
Step 2: Preparation
Apply adhesive between 18°C and 35°C. Shake can well before using. Surfaces must be clean, dry and free of foreign materials. Protect finished surfaces. Pre-fit all materials. Testing of substrates for compatibility is recommended. Turn spray tip so that the black dot is aligned with the nozzle.
Step 3: Application
Hold can in a vertical position. Point valve towards surface and spray from a distance of 8' to 10' (20 to 25 cm). Keep the can moving to create an even coat and avoid build-up on the surface. Start and stop the spray just off the work to prevent runs and sags.
For repositionable/temporary bonds: Apply a very light even coat to one surface. After 15 seconds, join with light pressure only.
For a permanent bond: Apply a medium coat to one surface. Allow to dry to tack and join.
For stronger permanent bonds: Apply a medium coat to both surfaces. Allow to dry to tack (1 to 10 minutes). Porous surfaces will require more than one coat.
Step 4: Cleanup
After use, invert spray can and spray for approximately 2 seconds (or until spray is free of adhesive) to clear valve and spray tip. Clean spray tip with turpentine or mineral spirits. Note: When using solvents for cleanup, use proper precautionary measure.